elevator car
英 [ˈelɪveɪtə(r) kɑː(r)]
美 [ˈelɪveɪtər kɑːr]
网络 电梯轿厢; 轿厢; 电梯车厢
英英释义
noun
- where passengers ride up and down
- the car was on the top floor
双语例句
- For optimization efficiency of the elevator, the elevator car occupancy percentage is an important data. Existing weight measure system can only measure the weight in the elevator car and can not identify the occupancy percentage.
对于电梯效率最优化而言，轿厢空间被占用面积是一个关键数据，但现有的电梯称重装置只能检测出轿厢中的重量，无法识别轿厢空间占用率。 - The light turns on as soon as the elevator car is activated, such as when the elevator doors open.
电梯启动像电梯开门这种情况下，灯会立即开启。 - A diagram showing the location of your elevators, car numbers and the elevator car phone number should be in your designated security area.
在指定的安全区域，应有一张体现电梯位置，电梯厢号以及电梯里电话号码的图表。 - PID control means is usually used in the current leveling precision control of the elevator car. It is difficult to meet the requirements for usage performance of elevator at high speed lifting.
在现有的电梯轿厢平层精度控制中，大都采用PID控制方式，难以满足高速电梯的使用性能要求。 - In the present study, a two-dimensional model of the elevator car and counter weight system was set up;
此外，本文还建立了全三维的电梯轿厢-对重模型，定量分析了气动力的大小。 - The vibration equations of elevator car and guide rail was established, and the relations of variables such as displacement, velocity and excitation force between guide rollers and rails were given by satisfying the geometry compatibility and force equilibrium condition.
分别建立轿厢与导轨振动分析数学模型，基于两者几何相容性与作用力平衡条件，给出导轨与导轮位移、速度、激振力耦合关系。 - The influence on traction capability caused by the change of elevator car's weight is analyzed in the terms of lift traction condition, for elevator rebuilding is always related to the car rebuilding.
在电梯改造过程中常涉及到对轿厢的改造。从电梯曳引条件的角度，分析了常见电梯轿厢重量改变对曳引能力的影响情况。 - Horizontal vibration model of elevator car
电梯轿厢水平振动模型 - ⑵ Through MATLAB software on traction elevators were 12 degrees of freedom vibration model and the horizontal direction perpendicular to 8 degrees of freedom vibration model simulation, respectively, high-speed elevator car by the maximum peak to peak vertical vibration and horizontal vibration of the dynamic model curve.
⑵利用MATLAB软件分别对曳引电梯的12自由度垂直振动模型和水平方向8自由度振动模型进行仿真，分别得到高速电梯轿厢垂直振动的最大峰峰值与水平振动的动力学模型曲线。 - An elevator car controller based on CAN bus is described. The functions, architecture, hardware and software and the communication protocol designing methods of this controller are introduced.
简述了一种基于CAN总线的电梯轿厢控制器，介绍了该控制器的功能、结构及其软硬件和通信协议的设计方法。